Mercedes GLS X166 - Repair abs pump

What is the ABS block?

Why is the ABS block essential?

The ABS block is a necessary part for the safety of a vehicle. The ABS block refers to the principle of anti-lock braking of the wheels to prevent, when braking too hard, the wheels from locking.

The ABS system for better control of the vehicle

Before explaining the ABS block in detail, it is important to understand the ABS system in its entirety. We can notice for the car Mercedes GLS X166 ...

• The ABS block: let's see precisely the elements that make it up below...
• The wheel speed sensors: we notice 2 types, the inductive sensors composed in particular of a permanent magnet and the active sensors.
• The magnetic targets: they vary the output signal which is in the form of a square signal of variable frequency.

The ABS block

Different elements of the ABS block Mercedes GLS X166 to know including...

The ECU

It informs the driver of a malfunction with a specific indicator on the dashboard.

The hydraulic unit

Many components make it up, including:

• Solenoid valves that eliminate the need for a brake compensator.
• A hydraulic pump whose action ejects the fluid stored in the accumulator to the master cylinder.
• Pressure accumulators which are none other than pressurized gas tanks used to provide a large flow rate for a fairly short time.

The hydraulic motor

Transfers hydraulic energy into mechanical energy.

How to replace Mercedes GLS X166 ABS block

How to tell if an ABS block is out of order

This is quite often one or the other reason... The car is unstable in wet driving conditions or the brake pressure regulation is not working properly.

What does Diag-Engine offer?

Diag-Engine is a company that is an expert in repairing the ABS block of all makes. It is important to understand that Diag-Engine does not sell any new ABS blocks.

Concretely...

7 days are enough for you to receive your ABS block in working condition.

You have to locate the reference of your defective ABS block to order its repair. Then all you have to do is pay for the part in your cart after choosing the make and model of car you own. Finally, send us your failed ABS block as soon as possible.

Do you have a doubt? Contact us and we will assist you.

The address to which you should send it to us is visible in the footer of the site.

Some customer comments

• The garage owner gave me an estimate of €1100 to replace my ABS block. Thanks to Diag-Engine, it cost me 400 €. Great thanks !
• I sent my ABS block to Diag-Engine and all the follow up and service were on point, from the contact to the repair and from the delay until the delivery.
• I'm not used to leave a review following a purchase, but there, I do it without hesitation for my ABS block Mercedes GLS X166 : 5 stars thanks !

Make your purchase in installments or later by credit card with the company Alma.